ETS-1000 - Ethernet analyzer

Cost-effective handheld Ethernet analyzer enabling service providers to turn-up and install Carrier Ethernet services.

  • Date discontinuée: 28/02/2017
  • Date de fin de service et de support: 28/02/2022

Caractéristiques principales

Two 10/100/1000BaseT and GigE independent test ports
Throughput, back-to-back, latency and frame loss measurements as per RFC 2544 (asymmetric results)
Multistream, up to layer 4 traffic generation and analysis, allowing quality of service (QoS) verification through VLAN, TOS/DSCP prioritization testing
MPLS route prioritization validation with up to three MPLS labels (MPLS option)
Cable diagnostics
Through mode testing for troubleshooting applications
TCP/IP network configuration test suite including, TCP client, DNS lookup and ARP monitor
Throughput, back-to-back, latency and frame loss measurements as per RFC 2544 (asymmetrical results optional)
Up to 10 traffic stream generation and analysis, perfect for turning-up next-generation Ethernet services
EtherBERT™ for bit-error-rate testing of 10, 100 and 1000 Mbit/s Ethernet circuits
MPLS support for Carrier Ethernet
Packet jitter measurement to qualify Ethernet transport networks for transmission of delay-sensitive traffic such as voice-over-IP (VoIP) and video
Remote control capability
Dual port capability for simultaneous traffic generation and reception at 100 % wire speed for 10/100/1000Base-T, 1000Base-SX, 1000Base-LX or 1000Base-ZX full-duplex networks at all packet sizes
Ethernet-in-the-First-Mile 802.3ah testing
Clear pass/fail test results
Through mode capability for troubleshooting applications
TCP/IP network configuration test suite including TCP client, DNS lookup, ARP monitor, ping and traceroute
Cable diagnostics

Description

Assessing Carrier Ethernet Services

EXFO’s ETS-1000 is a cost-effective handheld Ethernet analyzer enabling service providers to turn-up and install next-generation Carrier Ethernet services. Its compact size combined with a complete feature set makes it the perfect tool for field technicians to reliably validate service-level agreements (SLA) of Ethernet-based services running over metro Ethernet networks.

The ETS-1000 has two completely independent test ports that support the following interfaces: 10/100/1000Base-T, 1000Base-SX, 1000Base-LX and 1000Base-ZX. Using this analyzer, technicians can transmit up to layer-4 traffic with fully configurable virtual local area networks (VLAN), multiprotocol label switching (MPLS) and quality of service (QoS) parameters. The ETS-1000 supports all of today’s necessary Ethernet/IP field testing capabilities including the RFC 2544, bit-error-rate testing (BERT), packet jitter as well as multistream generation and analysis.

Soutien