IQS-8510G Packet Blazer - 10 Gigabit Ethernet test module

Delivers performance assurance for Ethernet-based frame services; provides all the measurements required for validating traffic, loading and service-level agreements (SLAs) between network elements.

  • Date discontinuée: 30/06/2016
  • Date de fin de service et de support: 30/06/2021

Caractéristiques principales

LAN and WAN PHY capability in a single module
Fully integrated functionality for assessing the performance of Ethernet transport networks
Complete EtherSAM (ITU-T Y.1564) test suite. EtherSAM is the new standard for turning up and troubleshooting mobile backhaul and business Ethernet services
Throughput, burstability (back-to-back), latency and frame loss measurements as per RFC 2544
EtherBERT™ test functionality for assessing the integrity of 10 Gigabit Ethernet running on WDM networks
Multistream generation and analysis, allowing quality of service (QoS) verification through VLAN and TOS/DSCP prioritization testing
MPLS, MPLS-TP, PBB-TE and IPv4/IPv6 support for complete Carrier Ethernet validation
Part of EXFO's unified layer 0/1/2/3/4 testing solution
Measures throughput, back-to-back (burstability), latency and frame loss as per RFC 2544
EtherBERT™ for bit-error-rate testing of 10 Gigabit Ethernet circuits
Performs packet jitter measurement (IP packet-delay variation as per RFC 3393) to qualify Ethernet transport networks for transmission of delay-sensitive traffic such as voice-over-IP (VoIP)
Q-in-Q capability with the ability to go up to three layers of stacked VLANs
LAN PHY and WAN PHY available in a single module
Simultaneous traffic generation and reception at 100 % wire speed for 10GBASE-SR, -ER, -LR, -SW, -EW or -LW full-duplex interfaces at all frame sizes
UDP, TCP and IP header integrity validation
Expert mode capability for defining test pass/fail thresholds
Fully complies with the IEEE’s 802.3ae standard
Pluggable XFP optical module
End-to-end testing using Smart Loopback
Service disruption test measurement
Transmits and analyzes up to ten streams, providing per-stream measurements for throughput, latency, frame loss and packet jitter
Bidirectional RFC 2544
Remotely controllable through Visual Guardian Lite software or VNC
Configurable advanced filters for in-depth network troubleshooting
PBB-TE and MPLS support for Carrier Ethernet
Internet protocol version 6 (IPv6 testing)

Applications

Performance validation of carrier-grade 10 Gigabit Ethernet services
End-to-end characterization and SLA validation

Soutien